星载天线基础结构特性对振动响应的影响分析

文章通过对星载天线振劫响应问题的分析,提出了提高设计质量和改进设计方法的建议：首先,在抽象和归类的基础上,将上／下层天线结构简化为二级隔振系统：通过对上／下层二级隔振系统分析,推导了传递函数。然后,通过改变下层结构的阻尼特性、质量特性和刚度特性,定量地分析了不同参数情况下传递函数的变化情况,最后．根据分析和计算结果,提出了一般的设计规则和建议．     

航天器视场遮挡分析方法研究

敏感器视场遮挡分析是航天器构型布局设计的重要组成部分，针对大型在轨变构型航天器敏感器视场遮挡分析工作量大、出错率高、遮挡率无法量化等特点，本文提出一种基于敏感器第一视角的视场遮挡快速分析方法。该方法通过设置第一视角图像蒙版及图像映射，模拟方锥形、圆锥形、球形等各类敏感器视场，通过逐个像素比对，计算视场遮挡率和遮挡方位。使用此方法建立了空间站敏感器视场遮挡分析系统，结果表明新方法能够显著提高视场遮挡分析效率和准确率，并且为机构类部件运动过程对敏感器视场遮挡的分析提供了有效工具。     

Predictive fault-tolerant control of an all-thruster satellite in 6-DOF motion via neural network model updating

The problem of controlling an all-thruster spacecraft in the coupled translational-rotational motion in presence of actuators fault and/or failure is investigated in this paper. The nonlinear model predictive control approach is used because of its ability to predict the future behavior of the system. The fault/failure of the thrusters changes the mapping between the commanded forces to the thrusters and actual force/torque generated by the thruster system. Thus, the basic six degree-of-freedom kinetic equations are separated from this mapping and a set of neural networks are trained off-line to learn the kinetic equations. Then, two neural networks are attached to these trained networks in order to learn the thruster commands to force/torque mappings on-line. Different off-nominal conditions are modeled so that neural networks can detect any failure and fault, including scale factor and misalignment of thrusters. A simple model of the spacecraft relative motion is used in MPC to decrease the computational burden. However, a precise model by the means of orbit propagation including different types of perturbation is utilized to evaluate the usefulness of the proposed approach in actual conditions. The numerical simulation shows that this method can successfully control the all-thruster spacecraft with ON-OFF thrusters in different combinations of thruster fault and/or failure.     

基于改进FCM的北斗三频组合观测值选取

以北斗卫星导航系统三频双差为基础探讨了组合观测值及误差,针对以往采用聚类方法在研究GPS三频组合数据过程中的不足,提出了基于距离修正的增量模糊C均值算法.通过调节因子有效地修正了样本中心与聚类中心的距离,获得合理的隶属度,从而得到正确的分类;构造了基于距离修正的聚类有效性指标,自动获取最佳聚类数,避免了人为确定聚类数的不合理性;在此基础上引入增量的思想,数据增加时以原有的数据集为基础,根据阈值进行归类,不需要重新进行初始计算.通过矩阵变换法及实例验证了该方法的可行性和可靠性.     

基于H∞方法的控制系统作动器最优控制仿真研究

在设计控制系统模型时,首先引入了有限差分法(FDM)离散化后的波动方程,然后基于H∞最优控制原理,检查闭环控制系统的稳定性和可探测性,对控制系统传感器和作动器的位置进行优化配置.通过计算闭环反馈系统的范数,最终得到了控制系统的最优控制算法.仿真结果表明,利用波动方程来优化控制系统传感器和作动器位置的算法是可行的,可广泛应用于飞控系统的设计中.     

Hypervelocity impact induced shock acoustic emission waves for quantitative damage evaluation using in situ miniaturized piezoelectric sensor network

Manmade debris and natural meteoroids, travelling in the Low Earth Orbit at a speed of several kilometers per second, pose a severe safety concern to the spacecraft in service through the HyperVelocity Impact(HVI). To address this issue, an investigation of shock Acoustic Emission(AE) waves induced by HVI to a downscaled two-layer Whipple shielding structure is performed,to realize a quantitative damage evaluation. Firstly a hybrid numerical model integrating smoothparticle hydrodynamics and finite element is built to obtain the wave response. The projectiles, with various impact velocities and directions, are modelled to impact the shielding structure with different thicknesses. Then experimental validation is carried out with built-in miniaturized piezoelectric sensors to in situ sense the HVI-induced AE waves. A quantitative agreement is obtained between numerical and experimental results, demonstrating the correctness of the hybrid model and facilitating the explanation of obtained AE signals in experiment. Based on the understanding of HVI-induced wave components, assessment of the damage severity, i.e., whether the outer shielding layer is perforated or not, is performed using the energy ratio between the regions of ‘‘high frequency" and ‘‘low frequency" in the acquired AE signals. Lastly, the direct-arrival fundamentalsymmetric wave mode is isolated from each sensing signal to be input into an enhanced delay-andsum algorithm, which visualizes HVI spots accurately and instantaneously with different sensor network configuration. All these works demonstrate the potential of quantitative, in situ, and real time HVI monitoring using miniaturized piezoelectric sensor network.     

存在干扰下的无人机中继站波束成形算法

无人机(UAV)通信具有部署快、使用灵活、通信质量好等优点,在无线通信领域具有广阔的应用前景。采用UAV作为中继站构成的增强型卫星通信网络经常受到各种干扰的影响,导致其性能急剧下降。以信干噪比(SINR)最大化为准则,UAV中继站发射功率满足要求为约束条件的优化问题的基础上,提出了一种基于最大瑞利熵的波束成形(BF)算法,得出最优权矢量。为了降低BF算法的实现复杂度,进一步提出了一种基于迫零(ZF)的次优BF算法。计算机仿真验证了这2种BF算法的有效性。     

边缘计算在电机远程运维系统中的应用探讨

介绍了边缘计算的基本概念及与云计算的对比。针对电机远程运维需求,介绍了电机远程运维系统的架构及主要功能。在描述边缘侧设备与远程运维平台的数据交互过程的基础上,详细阐述了边缘计算在电机远程运维系统中的应用。     

基于嵌入式FPGA加速ORB算法的遥感影像配准方法

卫星上计算资源有限，星载嵌入式处理器处理遥感影像的配准时通常需要很长的时间。可编程逻辑门阵列（FPGA）利用其内部可编程器件可用于加速图像处理。提出了一种基于Xilinx公司的ZYNQ芯片加速ORB算法的遥感影像配准方法，可用于3000×3000像素尺寸的卫星图像配准，缩短了计算耗时，提升了ORB算法的计算能效比。利用FPGA能够实现真正的并行计算电路，实现ORB算法多支路单层流水线的并行计算结构。采用软硬件结合的方法实现架构，能够处理不同分辨率的图像，可灵活配置特征点的数量。基于设计的加速ORB配准方法，获得了较高准确率。与软件实现相比,OVS-1A遥感影像偏移精度损失低于0.05个像元;GF.4遥感影像偏移精度损失小于0.9个像元。将ORB配准算法流程应用在ZYNQ7020上，耗时减少了57.50%。     

Evaluation and improvement of coastal GNSS reflectometry sea level variations from existing GNSS stations in Taiwan

Global sea level rise due to an increasingly warmer climate has begun to induce hazards, adversely affecting the lives and properties of people residing in low-lying coastal regions and islands. Therefore, it is important to monitor and understand variations in coastal sea level covering offshore regions. Signal-to-noise ratio (SNR) data of Global Navigation Satellite System (GNSS) have been successfully used to robustly derive sea level heights (SLHs). In Taiwan, there are a number of continuously operating GNSS stations, not originally installed for sea level monitoring. They were established in harbors or near coastal regions for monitoring land motion. This study utilizes existing SNR data from three GNSS stations (Kaohsiung, Suao, and TaiCOAST) in Taiwan to compute SLHs with two methods, namely, Lomb–Scargle Periodogram (LSP)-only, and LSP aided with tidal harmonic analysis developed in this study. The results of both methods are compared with co-located or nearby tide gauge records. Due to the poor quality of SNR data, the worst accuracy of SLHs derived from traditional LSP-only method exceeds 1?m at the TaiCOAST station. With our procedure, the standard deviations (STDs) of difference between GNSS-derived SLHs and tide gauge records in Kaohsiung and Suao stations decreased to 10?cm and the results show excellent agreement with tide gauge derived relative sea level records, with STD of differences of 7?cm and correlation coefficient of 0.96. In addition, the absolute GNSS-R sea level trend in Kaohsiung during 2006–2011 agrees well with that derived from satellite altimetry. We conclude that the coastal GNSS stations in Taiwan have the potential of monitoring absolute coastal sea level change accurately when our proposed methodology is used.